Loosen Garage Door Spring

Pull downward on the spring and reattach the hook at the lower end of the spring at the next link down the chain to increase the spring tension.

Loosen garage door spring.

Step 1 unplug the garage door opener and clamp the door to the track. There are two torsion springs at each side of the garage door. Locate a reddish color cone around the spring. Adjust the springs on both sides of the door the same way.

Pull this rope to release the door opener from the drive chain. Side mounted springs are long heavy springs mounted on each side of the upper garage door track. Unplug the opener if you have an automatic garage door. First thing that you should do is observe the torsion spring and the connected apparatus carefully.

If you want to remove standard garage torsion springs yourself follow this video s instructions. Through the use of pulleys they perform the same function as the torsion springs. Take note of the notches and screws that hold the torsion spring in place. The springs extend along the shaft and work by twisting as the garage door closes by means of cables attached to each side of the lowest garage door panel.

They give you more freedom to evenly coat hinges locks gears and springs. Close the garage door. Retest the door balance as you did in step 1. Position a sturdy ladder to the side of the springs rather than working directly in front of them for safety reasons.

The torsion spring helps the garage door open and close easily. Reattach the hook at the next link up to loosen the. Put on eye. This tension makes it easier to lift the garage door from its closed position.

If the garage door isn t opening or closing properly then check the tension on the torsion springs for needed adjustments. The springs will be under tension which increases the risk of injury. Disconnect the garage door opener so the door remains closed. Step 2 when the door is lowered the springs that raise the door are under tension.

They come under tension when the garage door is closed to make lifting the. If the door was closing too quickly move the spring to the next higher hole on the bracket. Call a professional if you don t feel confident dealing with a spring under this much tension. Use locking pliers or a c clamp to secure the door to the track to keep it from opening when you release the tension on the springs 1 x research sourcestep 2 loosen the set screws while holding each spring with a winding bar.

The door opener should have a rope attached to the garage door mechanism. It should be placed on the left hand side of the torsion spring and placed away from the garage door s center. If it was opening too quickly move it to the next lower hole. Garage door lubricants that are grease based go on by hand and are much messier.

The springs are located at the top inside part of the garage door.